As a first test i printed The vertex logo.
I used the default settings in the slicer software. It looks pretty well for a first time I think.
Some adjustments that I need to do are:
Position the Z-height of the starting position a bit lower. (The first layer didn't stick very well on the bed)
Lower the temperature (190-195°C should be enough for PLA, I used 210°C)
I used the default settings in the slicer software. It looks pretty well for a first time I think.
Some adjustments that I need to do are:
Position the Z-height of the starting position a bit lower. (The first layer didn't stick very well on the bed)
Lower the temperature (190-195°C should be enough for PLA, I used 210°C)